Icom IC-91A - Memory Clearing Procedure

72
8 MEMORY/CALL CHANNELS
■ Memory clearing
Contents of programmed memories can be cleared (blanked),
if desired.
qPush and hold [S.MW](MR) for 1 sec. to enter select mem-
ory write mode.
• 1 short and 1 long beeps sound.
•“
µµ
” indicator blinks.
• Do not hold [S.MW](MR) for more than 2 sec. otherwise the
memory contents will be copied to VFO.
wRotate [DIAL] to select the desired memory channel to be
cleared.
ePush [
∫∫
](2) or [
√√
](8) to select “CLEAR.”
rPush and hold [S.MW](MR) for 1 sec. to clear the contents.
• 3 beeps sound.
• The cleared channel changes to blank channel
• Return to select memory write mode.— “
µµ
” indicator blinks.
Push [VFO] to exit select memory write mode.
NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
146 010
BANKBANK :----:----
MNAME:MNAME:
SKIPSKIP :OFF:OFF
FMFM
r
µ
000
145 000
MNAME:MNAME:
SKIPSKIP :OFF:OFF
CLEARCLEAR
r
µ
005
A
FMFM
145 870
PSKIPPSKIP
145 000
BANKBANK :----:----
MNAME:MNAME:
SKIPSKIP :OFF:OFF
r
µ
005
BANKBANK :----:----
MNAME:MNAME:
SKIPSKIP :OFF:OFF
r
µ
005
A
FMFM
145 870
PSKIPPSKIP
VFO mode
Rotate [DIAL] to select
the desired channel.
Push
for 1 sec. to clear.
Push .
Return to the VFO mode.
Enter select memory
write mode.
Push
for 1 sec.
Push
to select CLEAR .
or