71
8
MEMORY/CALL CHANNELS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
■ Copying memory/call contents
This function transfers a memory channel’s contents to VFO
(or another memory/call channel). This is useful when search-
ing for signals around a memory channel frequency and for
recalling the offset frequency, subaudible tone frequency etc.
D Memory/call➪VFO
qSelect the memory (call) channel to be copied.
➥ Push [MR] or [CALL] to select memory mode or call
channel mode, then rotate [DIAL] to select the desired
channel.
wPush and hold [S.MW](MR) for 1 sec. to enter select mem-
ory write mode.
• 1 short and 1 long beep sound.
•“
µµ
” indicator blinks.
eRotate [DIAL] to select “VFO.”
rPush and hold [S.MW](MR) for 1 sec. to write the selected
channel contents to VFO mode.
• Returns to VFO mode automatically.
Holding [S.MW](MR) for 2 sec. at the step w, will also
copy the memory contents to VFO. In this case, the steps
e and r are not necessary.
D Memory/call➪memory/call
qSelect the memory (call) channel to be copied.
➥ Push [MR] or [CALL] to select memory mode or call
channel mode, then rotate [DIAL] to select the desired
memory channel.
wPush and hold [S.MW](MR) for 1 sec. to enter select mem-
ory write mode.
• 1 short and 1 long beep sound.
•“
µµ
” indicator blinks.
• Do not hold [S.MW](MR) for more than 2 sec. otherwise the
memory contents will be copied to VFO.
eRotate [DIAL] to select the target memory (call) channel.
rPush and hold [S.MW](MR) for 1 sec. again to copy.
To Next Page
Loading...
Need help?
General
