8-5
8
SCAN
■ Priority scan
Priority scan monitors a specified frequency (the prior-
ity channel) once every 1–16 sec. (programmable) dur-
ing any operation, such as receiving, scanning other
channels, etc. A total of 10 priority channels can be
programmed.
DD
Setting
q Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w Push [F-5•SCAN] to select scan setting screen.
e Push [F-1•PRIO] once to enter priority channel se-
lection.
r Rotate the main dial to select priority channel num-
ber.
• No.1 to No.9 are available.
t Push [F-1•PRIO], then rotate main dial to select the
desired memory channel as priority channel.
y Push [F-1•PRIO] to set the priority scan.
u Set the desired VFO or memory channel.
[F-1•PRIO] [EXIT/SET] Main dial [BANK]
DD
Priority scan operation
q Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w Select the desired VFO or memory channel.
e Select the desired operating mode when VFO is se-
lected.
• The operating mode can also be changed while scan-
ning.
r Set [SQUELCH] control open or closed.
• See page 9-2 for squelch condition.
t Push [PRIO] to start the priority scan.
•“ ” blinks while scan screen is dis-
played.
• “PRIO” blinks while monitoring the priority channel.
y To cancel the scan, push [PRIO].
• Pushing [F5•STOP] also cancels the scan.
• Pushing [EXIT/SET] closes the scan screen, if displayed.
Scan indicator and Priority scan number appear
Priority channel indicator
[EXIT/SET] [PRIO][SQUELCH]
• Monitoring the Priority channel
q Push and hold [PRIO] for 1 sec. to monitor the
priority channel.
• “PRIO” blinks while monitoring the priority channel.
w To cancel the monitoring, push [PRIO].
To Next Page
Loading...
Need help?
General
