4-6
4
RECEIVE MODES
■ TV channel operation
A TV tuner is built-in to the IC-R9500, and connects to
the [VIDEO IN] and [VIDEO OUT] on the rear panel
using a TV jumper cable to monitor the TV programs.
If you would rather use your TV tuner, connect the ex-
ternal tuner to [VIDEO IN] on the rear panel.
q Push [DISPLAY] once or twice to turn ON the de-
sired TV screen.
• Push once to turn ON the mini TV screen, push again
to turn ON the full TV screen and push again to close
the TV screen.
w Set the desired frequency and select WFM mode.
e Push [DISPLAY] to close the TV screen.
The TV display settings can be adjusted in display
set (Video) mode. (p. 11-24)
DD
Convenient functions for TV operation
• Preamp (p. 5-9)
➥ Push [P.AMP] several times to set the preamp
OFF, preamp 1 ON or preamp 2 ON. Only
ON/OFF is available above 30 MHz.
•“P.AMP1” or “P.AMP2” appears when the preamp 1 or
preamp 2 is ON below 30 MHz. “P.AMP ON” appears
above 30 MHz.
• Attenuator (p. 5-9)
➥ Push [ATT] several times to set the attenuator in
6 dB steps for HF bands, or 10 dB step for
30–1150 MHz. Only 20 dB is available for
1150–3335 MHz.
•“ATT” and attenuation level appear when the attenu-
ator is ON.
• Auto notch filter (p. 5-16)
➥ Push [NOTCH] switch to turn the auto notch func-
tion ON or OFF.
•Notch indicator (above [NOTCH] switch) lights when
either the manual notch is ON.
• VSC (voice squelch control) (p. 8-3)
➥ Push [VSC] to turn the VSC function ON or OFF.
• The VSC indicator appears when the voice squelch
function is set to ON.
• AFC (Auto Frequency Control) (p. 5-17)
➥ Push [AFC] to turn the AFC function ON or OFF.
• The AFC indicator appears when the AFC function is
set to ON.
To Next Page
Loading...
Need help?
General
