3-7
3
BASIC OPERATIONS
■ Operating mode selection
FM, WFM, AM, Synchronous-AM (S-AM(D)/S-
AM(U)/S-AM(L)), SSB (USB/LSB), CW, CW reverse
(CW-R), FSK, FSK reverse (FSK-R) and DIGITAL
(P25*) modes are available in the IC-R9500. Select the
desired operation mode as follows. * P25 requires op-
tional UT-122.
To select a mode of operation, push the desired mode
switch momentarily. Push the switch again to toggle
between AM and S-AM(D)/S-AM(U)/S-AM(L),
USB/LSB and CW/CW-R, if desired. Push and hold the
switch for 1 sec. to toggle between S-AM(D), S-AM(U)
and S-AM(L), USB and LSB, CW and CW-R, FSK and
FSK-R, if desired.
See the diagram below left for the order of selection.
• Selecting FM mode
➥ Push [FM] to select FM.
• Selecting WFM mode
➥ Push [WFM] to select WFM.
• Selecting AM mode
➥ Push [AM] to select AM or S-AM.
• After AM or S-AM is selected, push [AM] to toggle be-
tween AM and S-AM.
• After S-AM is selected, push and hold [AM] for 1 sec. to
toggle between S-AM(DSB), S-AM(USB) and S-
AM(LSB).
• Selecting SSB/CW mode
➥ Push [SSB/CW] to select SSB or CW.
• After SSB or CW is selected, push [SSB/CW] to toggle
between SSB and CW.
• After SSB or CW is selected, push [SSB/CW] for 1 sec.
to toggle between USB and LSB, or, CW and CW re-
verse mode, respectively.
• Selecting FSK mode
➥ Push [FSK] to select FSK.
• After FSK is selected, push [FSK] to toggle between
FSK and FSK reverse mode.
• Selecting DIGITAL mode (Requires optional U-122)
➥ Push [DIGITAL] to select digital (P25) mode.
To Next Page
Loading...
Need help?
General
