7-2
■ Memory channels
The receiver has 1220 memory channels. Memory
mode is very useful for quickly changing to often-used
frequencies.
All 1220 memory channels are tuneable which means
the programmed frequency can be tuned temporarily
with the main dial, etc. in memory mode.memory chan-
nel.
7
MEMORY OPERATION
MEMORY
CHANNEL
Regular memory
channels
Auto write mem-
ory channels
Skip memory
channels
Scan edge mem-
ory
channels
MEMORY
CHANNEL
NUMBER
0–999
(0–999)
A00–A99
(1000–1099)
S00–S99
(1100–1199)
P0A–P9B
(1200–1219)
CAPABILITY
For normal use. Frequency, mode, tuning
step, name, P.AMP/ATT information and etc.
can be programmed.
Frequencies detected during auto memory
write scan are memorized into this bank in
sequence. Mode and tuning step are written
at the same time. Note that when “Auto MW
Scan Memory Clear” in scan set mode is set
as “ON” and auto write scan is started, all
memories in this bank are cleared.
Undesired signals such as from beacons, con-
trol-coded signals, etc., can be programmed
to be skipped during programmed scan and
auto memory write scan. When [MW] is
pushed and held for 1 sec. while scan is
paused, the displayed frequency is pro-
grammed into this bank regardless of the
selected bank.
Memorize scan edge frequencies. 10 pairs of
scan edges (P0A to P9B) are programmable
(upper and lower scan edges). Mode and tun-
ing step are automatically equalized to the last
programmed channel in a pair.
TRANSFER
TO VFO
YES
YES
YES
YES
OVER-
WRITING
YES
YES
YES
YES
CLEAR
YES
YES
YES
YES
To Next Page
Loading...
Need help?
General
