8-15
8
SCANS
■ Skip scan
You can set the selected memory channel as a skip
channel which is skipped during memory scan. Its fre-
quency is also skipped during programmed and auto
memory write scans. This setting is useful to speed up
the scan speed.
DD
Specifying skip channels
q Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w Push [F-4•MEMORY] to select memory list screen.
e While pushing and holding [F-1•ROLL] or [F-2•SET],
rotate the main dial to select the memory channel to
be specified as a skip channel.
• [M-CH] (or [BANK]) control and direct keypad selection
can be used.
r Push [F-5•SKIP] to select the skip setting ON.
• “SKIP” indicator appears.
• Push [F-5•SKIP] again to select the skip setting OFF.
t Repeat steps e to r to program another memory
channel as a skip channel, if desired.
y Push [EXIT/SET] to exit the memory list screen.
DD
Programming skip frequencies (for programming scan)
q Start programming scan as described on page 8-7.
w When the scan pauses on an undesired signal, push
and hold [MW] for 1 sec.
• The frequency is memorized into the skip bank as a skip
frequency.
DD
Skip scan setting
q Push [F-5•SCAN] to select scan screen.
w Push [F-7•SET] to select scan set mode.
e Push [F-1•Y] to select “SKIP Function.”
r Rotate the main dial to select the desired condition.
• Push and hold [F-4•DEF] for 1 sec. to select the default
setting.
t Push [EXIT/SET] to return to scan menu.
To Next Page
Loading...
Need help?
General
