8-7
8
SCANS
DD
Programmed scan operation
q Push [EXIT/SET] several times to close a multifunc-
tion screen, if necessary.
w Select the desired VFO or memory channel.
e Select the desired operating mode.
• The operating mode can also be changed while scan-
ning.
r Set [SQUELCH] control open or closed.
• See page 8-3 for squelch condition.
t Push [PROG] to start the programmed scan.
• Scan screen appears.
•“ ” and decimal points blink while
scanning.
• Push numeral key (0–9) to change to the other edges.
y When the scan detects a signal, the scan stops,
pauses or ignores it depending on the resume set-
ting and the squelch condition.
u To cancel the scan, push [PROG].
• Pushing [F5•STOP] also cancels the scan.
• Pushing [EXIT/SET] closes the scan screen.
i Push and hold [F-6•RECALL] for 1 sec. to recall the
frequency that is set before starting the scan, if de-
sired.
If the same frequencies are programmed into the
scan edge memory channel PxA and PxB, pro-
grammed scan does not start.
✔
For your convenience
Ten programmed scans can be selected directly from
the keypad. Then the scan starts immediately.
➥ Push numeral key (0–9) then push [PROG] to start
the desired programmed scan.
To Next Page
Loading...
Need help?
General
