3-2
■ When first applying power (CPU resetting)
Before first applying power, make sure all connections
required for your system are complete by referring to
Section 2. Then, reset the receiver using the following
procedure.
Resetting CLEARS all programmed contents in
memory channels and returns programmed values
in set mode to default values.
q Turn the main power ON with [I/O] on the rear
panel.
• The receiver power is still OFF and the [POWER] indi-
cator lights orange.
w While pushing and holding [CE] and [M-CL], push
[POWER] to turn power ON.
• The CPU is reset.
• The CPU start-up takes approx. 5 sec.
• The receiver displays its initial VFO frequencies when
resetting is complete.
e Change the set mode settings after resetting, if de-
sired.
In cooler temperatures, the LCD may appear dark
and unstable after turning power ON. This is normal
and does not indicate any equipment malfunction.
■ Initial settings
After resetting the receiver, set controls as shown in
the figure below.
To Next Page
Loading...
Need help?
General
