8
D-STAR OPERATION <BASIC>
8-10
■ Setting “TO” (Destination) (Continued)
D Using “Gateway CQ” (Gateway call)
The destination repeater is set in “TO” to call a station
through your local area (access) repeater, gateway
repeater, the internet and then to your destination re-
peater.
q Hold down for 1 second.
• The DR screen appears.
w Push D-pad() to select “TO” (Destination), and then
push D-pad(Ent).
e Push D-pad() to select “Gateway CQ,” and then
push D-pad(Ent).
• The REPEATER GROUP screen is displayed.
r Push D-pad() to select the repeater group where
your destination repeater is listed, and then push D-
pad(Ent).
• Example: “11: Japan”
t Push D-pad() to select the destination repeater,
and then push D-pad(Ent).
• Example: “Hamacho”
• “Hamacho” is displayed in “TO.”
Example: Making a gateway CQ call to (Japan; Hama-
cho) from the “Hirano” repeater.
Completed
TIP: After selecting a repeater, you can select other
repeaters in your transceiver by rotating [DIAL].
Means this repeater
is the 282nd of the
690 repeaters on the
Repeater List.
NOTE: When you set the repeater that has no gate-
way call sign in “FROM,” “ ” appears.
In this case, you cannot make a gateway call.
To Next Page
Need help?
General
