8
D-STAR OPERATION <BASIC>
8-11
■ Setting “TO” (Destination) (Continued)
D Using “Your Call Sign”
The “Your Call Sign” memory stores the “UR” (destina-
tion) call signs.
When you select an individual station call sign for the
“TO” (Destination) setting as “Your Call Sign,” a gate-
way call can be made.
When you call a destination through the gateway, the
signal is automatically sent to the last repeater that the
station accessed.
So, even if you don't know where the station is, you can
still make a call to it.
q Hold down for 1 second.
• The DR screen appears.
w Push D-pad() to select “TO,” and then push D-
pad(Ent).
e Push D-pad() to select “Your Call Sign,” and then
push D-pad(Ent).
r Push D-pad() to select the destination, and then
push D-pad(Ent).
• Example: “TOM”
• “TOM” is displayed in “TO.”
TIP: After selecting a destination, you can select other
stations in your transceiver by rotating [DIAL].
Example: Select “TOM” from the “Your Call Sign.”
The call sign of
the selected sta-
tion is displayed.
Completed
Means this station
is programmed as
the 33rd of the 33
stations on your
memory.
NOTE: When you set the repeater that has no gate-
way call sign in “FROM,” “ ” appears.
In this case, you cannot make a gateway call.
To Next Page
Loading...
Need help?
General
