8
D-STAR OPERATION <BASIC>
8-19
■ Reflector operation (Continued)
D Unlinking a reflector
Before linking to another reflector, be sure to unlink the
current reflector.
q Hold down for 1 second.
• The DR screen appears.
w Push D-pad() to select “TO,” and then push D-
pad(Ent).
e Push D-pad() to select “Reflector,” and then push
D-pad(Ent).
• The “REFLECTOR” screen appears.
r Push D-pad() to select “Unlink Reflector.”
t PushD-pad(Ent).
• The transceiver returns to the DR screen.
• “Unlink Reflector” and “U” are displayed in “TO.”
y Hold down [PTT] to unlink the reflector.
• The TX/RX indicator lights red.
D Reflector Echo Testing
This function is a useful check of how well your signal
is getting into the repeater, and you can use it to verify
that your repeater is operating normally.
q Hold down for 1 second.
• The DR screen appears.
w Push D-pad() to select “TO,” and then push D-
pad(Ent).
e Push D-pad() to select “Reflector,” and then push
D-pad(Ent).
• The “REFLECTOR” screen appears.
r Push D-pad() to select “Echo Test.”
t PushD-pad(Ent).
• The transceiver returns to the DR screen.
• “Echo Test” and “E” are displayed in “TO.”
y Hold down [PTT] and speak at your normal voice
level.
• The TX/RX indicator lights red.
u Release [PTT] to hear your message.
To Next Page
Loading...
Need help?
General
