BIOS Setup Interface Intel® Server Board S1200V3RP TPS
Revision 1.2
4. Discard Changes
Option Values: <None>
Help Text:
Discard Changes made so far to any of the setup options.
Comments: Selection only. Select this line and press the <Enter> key to
discard any pending unsaved changes in BIOS settings. If there have been no changes
made in the settings, the BIOS will resume executing POST.
If changes have been made in BIOS settings and not yet saved, a confirmation pop-up
will appear. If the “Discard Changes” action is positively confirmed, all pending changes
will be discarded and BIOS will resume executing POST. If the “Discard Changes” action
is not confirmed, BIOS will resume executing Setup without discarding pending changes.
Back to [Save & Exit Screen] — [Screen Map]
5. Load Default Values
Option Values: <None>
Help Text:
Load Defaults Values for all the setup options.
Comments: Selection only. Select this line and press the <Enter> key to load
default values for all BIOS settings. These are the initial factory settings (“failsafe”
settings) for all BIOS parameters.
There will be a confirmation popup to verify that the user really meant to take this action.
After initializing all BIOS settings to default values, the BIOS will resume executing
Setup, so the user may made additional changes in the BIOS settings if necessary (for
example, Boot Order) before doing a “Save Changes and Exit” with a reboot to make the
default settings take effect, including any changes made after loading the defaults.
The <F9> function key may also be used from anyplace in Setup to initiate a “Load
Default Values” action.
Back to [Save & Exit Screen] — [Screen Map]
6. Save as User Default Values
Option Values: <None>
Help Text:
Save the changes made so far as User Default Values.
To Next Page
Loading...
Need help?
General
