BIOS Architecture Intel® Server Board SE7520BD2 Technical Product Specification
46 Revision 1.3
3.2.5.5.1 USB Mass Storage Device Configuration Sub-menu
Table 20. BIOS Setup, USB Mass Storage Device Configuration Sub-menu Selections
Feature Options Help Text
Description
USB Mass Storage Device Configuration
USB Mass Storage
Reset Delay
10 Sec
20 Sec
30 Sec
40 Sec
Number of seconds POST waits for the USB
mass storage device after start unit command.
Device #1 N/A N/A Only displayed if a device
is detected, includes a
DeviceID string returned
by the USB device.
Emulation Type Auto
Floppy
Forced FDD
Hard Disk
CDROM
If Auto, USB devices less than 530MB will be
emulated as Floppy and remaining as hard drive.
Forced FDD option can be used to force a HDD
formatted drive to boot as FDD (Ex. ZIP drive).
Device #n N/A N/A Only displayed if a device
is detected, includes a
DeviceID string returned
by the USB device.
Emulation Type Auto
Floppy
Forced FDD
Hard Disk
CDROM
If Auto, USB devices less than 530MB will be
emulated as Floppy and remaining as hard drive.
Forced FDD option can be used to force a HDD
formatted drive to boot as FDD (Ex. ZIP drive).
3.2.5.6 PCI Configuration Sub-menu
This sub-menu provides control over PCI devices and their option ROM’s. If the BIOS is
reporting POST error 146, use this menu to disable option ROM’s that are not required to boot
the system.
Table 21. BIOS Setup, PCI Configuration Sub-menu Selections
Feature Options Help Text Description
PCI Configuration
Onboard Video Disabled
Enabled
Enable/Disable on board VGA
Controller
Dual Monitor Video Disabled
Enabled
Select which graphics controller to
use as the primary boot device.
Enabled selects the on board device.
Grayed out if Onboard
Video is set to "Disabled."
Onboard NIC 1 (Bottom) Disabled
Enabled
Enable/Disable OnBoard NIC 1.
Onboard NIC 1 ROM Disabled
Enabled
Enable/Disable OnBoard NIC 1 ROM. Grayed out if device is
disabled.
Onboard NIC 2 (Top) Disabled
Enabled
Enable/Disable OnBoard NIC 2.
To Next Page
Loading...
Need help?
General
