ITech IT7800 Series User Manual

System-Related Functions
Copyright ©ITECH Electronic Co., Ltd. 75
menu. The detailed parameter description is as below.
External program
External analog function
Status
Set the ON/OFF state
Mode
⚫ AM: Adjust the amplitude
⚫ Amplifier: Monitor the real-time output
values
Monitor
phase
When under 3-phase mode, select the
phase to be monitor.
Invalid under single phase mode.
U ratio
Set the ratio between the external signal
and the output voltage.
Can be set to 50V/1 or 100V/1
I ratio
Set the ratio between the external signal
and the output voltage.
Can be set to 5A/1 or 10A/1
1. Press the composite keys [Shift] + (System) on the front panel to
enter the system menu.
2. Press the up/down key or rotate the knob to select Source->External
programme and press [Enter].
Set the External control state and control mode, press [Enter].
Remote Control
Through the analog input interface, the analog signal can be input to remotely
set the output voltage value or power amplification function. For the detailed
function definition of the pin, please refer to the definition of the analog pins
description. The following is an example of amplitude modulation to introduce
how to connect and how to use.
When the voltage setting is controlled through the analog interface, the external
voltage (-10V ~ 10V) is connected to program the voltage value between 0 and
full scale(AC mode).
For example, analog control AC range of 0~350V voltage, when the analog
signal voltage is set to 5V, the voltage ratio set to 50V/1 under source menu, the
instrument output voltage is set to 5*50=250V.
When parallel machine operation, can be controlled through the host analog
interface.

ITech IT7800 Series Specifications

General

Brand	ITech
Model	IT7800 Series
Category	AC Power Distribution
Language	English