To Next Page

To Previous Page

SOURce Subsystem

[SOURce:]RESistance:VDRop

This command is used to set the CR mode and the LED Cut-off voltage value

when the LED test function is enabled.

Command Syntax

[SOURce:]RESistance:VDRop <NRf+>

Parameters

0 through MAX | MINimum | MAXimum | DEFault

Unit

V (volts)

*RST Value

MINimum

Examples

RES:VDR 5

Query Syntax

[SOURce:]RESistance:VDRop? [ MINimum | MAXimum | DEFault ]

Returned Parameters

<NR3>

Related Commands

VOLT:VDR

[SOURce:]RESistance:LED[:STATe]

This command enables or disenables the LED test option in CR mode.

Command Syntax

[SOURce:]VOLTage:LED[:STATe] <b>

Parameters

0 | 1 | ON | OFF

*RST Value

ITech IT8702 Programming Guide

Other manuals for ITech IT8702