ITech IT8702 Programming Guide

Programming Examples
Copyright © Itech Electronic Co., Ltd. 111
Chapter14 Programming Examples
13.1 Introduction
This chapter contains examples on how to program your electronic load. Simple
examples show you how to program:
 Input functions such as voltage, current, and resistance
 Transient functions, including lists
 Measurement functions
 The status and protection functions
NOTE: These examples in this chapter show which commands are used
to perform a particular function, but do not show the commands being
used in any particular programming environment.
13.2 Programming the Input
13.2.1 Power-on Initialization
When the electronic load is first turned on, it wakes up with the input state set
OFF. The following commands are given implicitly at power-on:
 *RST or *RCL 0
 *CLS
 *SRE 0
 *ESE 0
*RST is a convenient way to program all parameters to a known state. Refer to
the *RST command in chapter 4 to see how each programmable parameter is
set by *RST. Refer to the *PSC command in chapter 4 for more information on
the power-on initialization of the *ESE and the *SRE registers.
13.2.2 Enabling the Input
To enable the input, use the command:
INPut ON

ITech IT8702 Specifications

General

Brand	ITech
Model	IT8702
Category	Test Equipment
Language	English