ITech IT8702 Programming Guide

SOURce Subsystem
Copyright © Itech Electronic Co., Ltd. 71
[SOURce:]TRANsient
This command turns the transient generator on or off.
Command Syntax
[SOURce:]TRANsient[:STATe] <bool>
Parameters
0 | 1 | OFF | ON
*RST Value
OFF
Examples
TRAN 1
Query Syntax
[SOURce:]TRANsient[:STATe]?
Returned Parameters
0 | 1
Related Commands
CURR:TRAN:CURR:MODE CURR:TRAN:ALEV
[SOURce:]INPut:PROTection:CLEar
This command clears the latch that disables the input when a protection
condition such as overvoltage (OV) or overcurrent (OC) is detected. All
conditions that generated the fault must be removed before the latch can be
cleared. The input is then restored to the state it was in before the fault
condition occurred.
Command Syntax
[SOURce:]INPut:PROTection:CLEar
Parameters
None
Examples
INP:PROT:CLE

ITech IT8702 Specifications

General

Brand	ITech
Model	IT8702
Category	Test Equipment
Language	English