Error Messages
Copyright © Itech Electronic Co., Ltd. 117
Chapter15 Error Messages
Error Number List
This appendix gives the error numbers and descriptions that are returned by
the electronic load. Error numbers are returned in two ways:
Error numbers are displayed on the front panel
Error numbers and messages are read back with the SYSTem:ERRor?
query. SYSTem:ERRor? returns the error number into a variable and
returns two parameters, an NR1 and a string.
The following table lists the errors that are associated with SCPI syntax errors
and interface problems. It also lists the device dependent errors. Information
inside the brackets is not part of the standard error message, but is included for
clarification. When errors occur, the Standard Event Status register records
them in bit 2, 3, 4, or 5:
Command Errors 100 through 199 (sets Standard Event Status Register bit #5
CME)
Error Error String
101 device independed error
Too many numeric suffices in Command Spec
110 No Input Command to parse
114 Numeric suffix is invalid value
116 Invalid value in numeric or channel list, e.g. out of range
117 Invalid number of dimensions in a channel list
120 Parameter of type Numeric Value overflowed its storage
130 Wrong units for parameter
140 Wrong type of parameter(s)
150 Wrong number of parameters
160 Unmatched quotation mark (single/double) in parameters
165 Unmatched bracket
170 Command keywords were not recognized
180 No entry in list to retrieve (number list or channel list)
190 Too many dimensions in entry to be returned in parameters
191 Too many char
To Next Page
Loading...
Need help?
General
