Cleaning the Pre-Cleaner
Note: Do not run the engine with the filter pre-cleaner or the
rain cap removed. If the pre-cleaner is more than a third full
of dust, empty it.
1 Remove the Cover
Unscrew the wingnut A and lift off the cover B.
2 Empty and Clean the Bowl
Carefully remove the dust bowl C and empty out the
dust. Make sure the dust does not fall into the air filter
intake. Wipe the bowl clean. Remove oil or grease by
washing in hot water with a little detergent. Dry the
bowl before refitting it.
3 Fit the Bowl
Carefully set the bowl in position on the air filter. Fit and
tighten the wingnut.
13 - 1
Section 3 Routine Maintenance
9803/7130
Section 3
13 - 1
Issue 1
Engine Air Filter
S111320
AA
BB
CC
To Next Page
Loading...
Need help?
General
