− 11 −
1
Fix interlining installing plate
1
to the
machine frame with two screws
2
.
2
Set interlining as shown in the gure above.
The roll core that can be used is 40 to 70 mm wide and 200 mm in roller diameter (max.).
3
Pass the interlining between guide B and guide A and roller, and route it up above the table.
Roller
Guide B
Guide A
Sewing table
Set collar
Spring
Side plate
2
1
Guide plate
Guide B
Interlining
Feed the interlining up to the roller section using the notch of the guide plate.
4
Adjust the lateral position of two guides, two guide pins and side plate (on the right) to allow the
interlining to be fed straight up above the sewing table.
5
Position the set collar on the left-hand side to allow the side plate to lightly hold the interlining by
spring. Then x the set collar there.
Notch
CAUTION
:
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
13. INSTALLING SA-120 (INTERLINING SUPPLYING DEVICE)
(OPTIONAL PART NO. : 40045772)
To Next Page
Loading...
Need help?
General
