− 3 −
#
. SPECIFICATIONS
1. MECHANICAL SPECIFICATIONS
1 Sewing machine LH-896 model of 2-needle, lockstitch machine with a center knife
2 Sew
ing speed 3,000 sti/min (max.)
3 St
itch length Lockstitch: 2.0 to 3.4 mm (standard: 2.5 mm)
Condensation stitch: 0.5 to 1.5 mm (standard: 1.0 mm)
Back tack stitch: 0.5 to 3.0 mm (standard: 2.0 mm)
Condensation/Back tack stitch selectable
4 Types of welt Parallel double welt, parallel single welt
slant double welt, slant s
ingle welt
Each with ap or without ap
5 Pocket lip size
(Welt lenght)
Possible to set in increments of 0.1 mm within the range of 18 mm (min.) to 220 mm (max.)
* Parallel ap : Min. 47.5 mm
* Slant ap : Dependent on deection amount
(Reference) 20 mm gauge, deection amount 20 mm, back-tuck 7.5 mm
/
M
in. 67.5 mm
6 W
elting width
(Needle gauge)
8, 10, 12, 14, 16, 18and 20 mm
* However, for
with dart stretcher, 8, 10, and 12 mm
For
with breast pocket, 8, 10 and 12 mm
For
with zipper attachment, 16 mm, 18 mm, 20 mm
7 Needles ORGAN DP X 17 #14 to #18 (standard #16)
8 Thread Spun thread #60 (Recommended)
9 Hook Full rotary, vertical-axis, self-lubrication hook
10 Thread take-up lever Slide thread take-up lever
11 Needle bar stroke 33.3mm
12 Cloth feed mechanism Dr
iven by stepping motor
13 Control By a micro-computer
14 Safety mechanism
Machine operation is automatically stopped if the cloth feed mechanism error detector,
the needle thread breakage detector or any of the various safety devices is actuated.
15 Lubr
icating oil JUKI New Defrix Oil No. 1
16 Operat
ing air pressure 0.5MPa
17 Air consumption Approx. 40dm
3
/min.(ANR)
18 Dimensions of machine W
idth : 1,095 mm
(1,580 mm - when including the stacker)
Length : 1,500 mm
Height :
1,165 mm
(1,800 mm - when including the thread stand)
19 Weight 238.5kg
20 No
ise - Equivalent continuous emission sound pressure level (L
pA
) at the workstation :
A-weighted value of 80.0 dB; (Includes L
pA
= 2.5 dB); according to ISO 10821- C.6.3
-ISO 11204 GR2 at 3,000 sti/min for the sewing cycle, 4.8s ON.
(Pattern : No.1, Jump feed speed of clamp foot : Max speed)
2. ELECTRICAL SPECIFICATIONS
1
The number of independent sewing patterns that can
be stored in memory
99 (1 to 99)
2
The number of alternate sewing patterns that can be
stored
in memory
20 (1 to 20)
3
The number of cycles that can be stored in memory 20 (1 to 20)
4 Input power: Single phase/3-phase 200 to 240V 50/60 Hz (Opt
ional 380V)
Voltage uctuation : Within + 10% of the rated voltage
5 Power consumption 350VA
To Next Page
Need help?
General
