− 102 −
(1) Grease-up procedure
1
Loosen two screws
1
(SM6040602TP) and
move wiper cylinder
2
to the right side.
3
Replenishment of grease to the center knife
section
• Apply grease to both planes of guides
8
, knife
bar metal, upper
9
, and knife bar metal, lower
6
.
• Knife bar
!0
moves up and down by moving
cylinder joint
7
up and down in the state that air
is not supplied. Apply grease to the metal so as
to inltrate the inside.
1
2
8
9
!0
6
7
A
5
4
3
2
Loosen two screws
3
(SM4050655SP) and
move face plate cover
4
to the left side. At
this time, be careful of moving the cover along
escape
A
of the cover so that it does not come
in contact with plate spring
5
.
To Next Page
Loading...
Need help?
General
