− 94 −
(4) Take-in of the data
1
Display the communication screen
When COMMUNICATION key
of switch seat section is
pressed in the input screen, the communication screen (screen A)
is displayed.
2
Select the communication procedure
There are four communication procedures as described below.
A
Writing data from media to panel
B
Writing data from personal computer (server) to panel
C
Writing data from panel to media
D
Writing data from panel to personal computer (server)
Select the button of communication procedure you desire.
3
Select the data No.
When
E
is pressed, the writing le selection screen is
displayed.
Input the le No. of the data you desire to write. For the le No.,
input APW×××. of the le name and the numerals of the part ×××
of EPD. Designation of the pattern No. of writing destination can
be performed in the same way. When the writing destination is the
panel, pattern Nos. which have not been registered are displayed.
4
Determine the data No.
When ENTER button
F
is pressed, the data No. selection
screen is closed and the screen returns to the communication
screen (screen A).
5
Start communication
When COMMUNICATION START button
G
is pressed, the
data communication starts.
The during communication is displayed during communication
and the screen returns to the communication screen after the end
of communication.
Do not open the cover during reading the data. Data may not
be read in.
B
F
D
A
C
E
Communication screen
(screen A)
G
To Next Page
Loading...
Need help?
General
