− 51 −
(2) Sewing data list
1
Items that are displayed in the data input screen
. . . Item that is not displayed due to other setting state
No. Item
Setting range
/
Edit unit
Initial value
Motion mode change-over
With/without of motion of sewing machine motor, center knife and corner
knife is selected.
- - -
Cloth feed mode
Cloth feed, sewing
machine thread trimming
and center knife mode
Cloth feed, sewing
machine thread trimming
Cloth feed, sewing
machine thread trimming,
center knife and corner
knife mode
Sewing mode change-over
Sewing mode is selected.
＊
In case of alternate sewing, ap priority sewing is set with .
- - -
L size sewing Left ap sewing
Right ap sewing Flap priority sewing
L size setting
In case of L size sewing, the sewing length is set.
＊
It is possible to set only when setting L size sewing .
18.0 to
220.0
/
0.1mm
150.0mm
Marking light irradiation position change-over
Sewing start irradiation/sewing end irradiation/center irradiation is
selected.
- - -
Sewing start irradiation Sewing end irradiation
Center irradiation
Flap concealed stitching data (Left sewing start)
Position of sewing start of left-hand ap is adjusted.
＊
It is possible to set only when is set to ap sewing.
–9.9 to 9.9
/
0.1mm
0.0mm
Flap concealed stitching data (Left sewing end)
Position of sewing end of left-hand ap is adjusted.
＊
It is possible to set only when is set to ap sewing.
–9.9 to 9.9
/
0.1mm
0.0mm
Flap concealed stitching data (Right sewing start)
Position of sewing start of right-hand ap is adjusted.
＊
It is possible to set only when is set to ap sewing.
–9.9 to 9.9
/
0.1mm
0.0mm
To Next Page
Loading...
Need help?
General
