− 66 −
. . . Item that is not displayed due to other setting state.
No. Item
Setting range
/
Edit unit
Initial value
Stacker timer 3
Motion time of material sweeping bar is set.
＊
It is possible to set only when clamp bar stacker option is
used.
0.00 to
9.99
/
0.01 sec.
0.70 sec.
Stacker timer 4
Time to advance timing to release the sewing product by lifting clamp
foot is set.
When clamping a short sewing product, the amount to drop by tare is
adjusted.
＊
It is possible to set only when clamp bar stacker option is
used.
0.00 to
9.99
/
0.01 sec.
0.00 sec.
Sewing speed under the high-speed mode
Number of revolutions of lockstitch section is set.
＊
It is possible to set only when
sewing speed setting
selection is set to memory switch.
1000 to
3000
/
100
sti/min
2500sti/min
Sewing speed under the low-speed mode
Number of revolutions of condensation and back tack sewing sections
is set.
＊
It is limited by sewing speed under the high-speed mode.
＊
It is possible to set only when sewing speed setting
selection is set to memory switch.
1000 to
2500
/
100
sti/min
1500sti/min
Soft start, rst stitch
Number of revolutions of rst stitch at sewing start is limited.
500 to
2500
/
100
sti/min
500sti/min
Soft start, second stitch
Number of revolutions of second stitch at sewing start is limited.
500 to
2500
/
100
sti/min
700sti/min
Soft start, third stitch
Number of revolutions of third stitch at sewing start is limited.
500 to
2500
/
100
sti/min
1000sti/min
Return speed of clamp foot
Return speed of clamp foot is set.
3 to 9
/
1
7
Thread breakage detection
With/without thread breakage detection is selected.
- - -
With thread
breakage detection
Without thread
breakage detection
Flap presser motion mode
Motion order of ap presser is selected.
From right From left
Right/Left at the
same time
Side where ap is
put
＊
When right and left are simultaneously actuated with customizing of
pedal setting, this parameter is neglected and the right and left are
simultaneously actuated.
To Next Page
Loading...
Need help?
General
