– 142 –
<Condensation custom pattern list screen>
1. In the case of setting the number of stitches
Condensation custom pattern input procedure is
described as follows using < Figure: Example of
the condensation custom pattern > as an example.
The number of stitches can be input in the
range from 1 to 100.
Set the number of stitches for step 1 to 3 with
numeric keypad
❽
for the number of stitches
and
❾
.
Press
to confirm the setting.
⑤
Conrming the numeric value
Press
to conrm the setting.
<Condensation custom pattern list screen>
<Condensation custom edit screen>
The condensation custom list screen is displayed
with the condensation custom number you have
created added.
2. In the case of setting the stitch length
The pitch can be input in the range from ‒9.0 to 9.0 mm. Set the stitch length for step 1 to 1.0 mm using
numeric keypad
and
. Press
to conrm the setting.
A negative number of stitches can also be set. In this case, the direction of feed is reverse direction.
3. Carry out the following setting in the similar manner.
The number of stitches for step 2: 4 stitches
Stitch length for step 2: 1.5 mm
The number of stitches for step 3: 3 stitches
Stitch length for step 3: 1.0 mm
The number of stitches for step 4: 3 stitches
Stitch length for step 4: -1.0 mm
The number of stitches for step 5: 2 stitches
Stitch length for step 5: 1.5 mm
❽
❾
To Next Page
Loading...
Need help?
General
