– 143 –
9-5-3. Condensation custom edit function
①
Selecting the condensation custom edit function
<Condensation custom edit screen>
②
Editing the condensation custom value
1) In the case of setting the number of stitches
The number of stitches can be input in the range from 1 to 100.
Change the number of stitches for step 1 using the numeric keypad and for the number of
stitches.
Press to conrm the setting.
2) In the case of setting the stitch length
The stitch length can be input in the range from -9.0 to 9.0 mm.
Change the stitch length for step 1 using the numeric keypad and for the stitch length.
Press to conrm the setting.
* A negative number of stitches can also be set. In this case, the direction of feed is reverse direction.
3) Change the settings for each step in the same manner as described above.
Display the "condensation custom edit screen"
referring to
"9-5-2. Creating a new condensa-
tion custom" p. 140
.
In this section, procedure for editing the condensation custom value is described.
Refer to
"9-5-2. Creating a new condensation custom" p. 140
for the explanation of screen.
Steps of procedure to be taken after the aforementioned step are same as those described in
"9-5-2. Creat-
ing a new condensation custom" p. 140
.
To Next Page
Loading...
Need help?
General
