Juniper SRX220 Hardware Guide

• Using the Reset Config Button on the SRX220 Services Gateway on page 112
Using the Reset Config Button on the SRX220 Services Gateway
If a configuration fails or denies management access to the services gateway, you can
use the RESET CONFIG button to restore the device to the factory-default configuration
or a rescue configuration. For example, if someone inadvertently commits a configuration
that denies management access to a services gateway, you can delete the invalid
configuration and replace it with a rescue configuration by pressing the RESET CONFIG
button.
NOTE: The RESET CONFIGbuttonis recessedto prevent it from being pressed
accidentally.
The rescue configuration is a previously committed, valid configuration. You must have
previously set the rescue configuration through the J-Web interface or the CLI.
To press the RESET CONFIG button, insert a small probe (such as a straightened paper
clip) into the pinhole on the front panel.
•
By default, pressing and quickly releasing the RESET CONFIG button loads and commits
the rescue configuration through the J-Web interface or the CLI. The Status LED is solid
amber during this time.
•
By default, pressing and holding the RESET CONFIG button for 15 seconds or more—until
the Status LED is solid amber — deletes all configurations on the device, including the
backup configurations and rescue configuration, and loads and commits the factory
configuration.
For details about factory-default settings, see Viewing Factory Default Settings of the
SRX240 Services Gateway.
For details about performing initial software configuration, see the following topics:
•
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
J-Web Interface
•
Performing Initial Software Configuration on the SRX240 Services Gateway Using the
CLI
Related
Documentation
Changing the Reset Config Button Behavior on the SRX220 Services Gateway on
page 113
•
• Monitoring the SRX220 Services Gateway Chassis Using the CLI on page 105
• Monitoring the SRX220 Services Gateway Components Using LEDs on page 106
• Monitoring the SRX220 Services Gateway Using Chassis Alarm Conditions on page 109
• Monitoring the SRX220 Services Gateway Power System on page 110
• Juniper Networks Technical Assistance Center on page 113
Copyright © 2016, Juniper Networks, Inc.112
SRX220 Services Gateway Hardware Guide for H Model Numbers

Juniper SRX220 Specifications

General

Brand	Juniper
Model	SRX220
Category	Gateway
Language	English