CHAPTER 12
Installing the Services Gateway
•
Installing the SRX220 Services Gateway in a Rack on page 57
•
Installing the SRX220 Services Gateway on a Wall on page 60
•
Replacing or Installing Mini-Physical Interface Modules in the SRX220 Services
Gateway on page 62
Installing the SRX220 Services Gateway in a Rack
You can front-mount the SRX220 Services Gateway in a rack. Many types of racks are
acceptable, including four-post (telco) racks, enclosed cabinets, and open-frame racks.
For more information about the type of rack or cabinet into which theSRX220 Services
Gateway can be installed, see “SRX220 Services Gateway Rack Requirements” on page 32.
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
NOTE:
•
If you are installing multiple devices in one rack, install the lowest one first
and proceed upward in the rack.
•
Make sure that the rubber feet from the base of the chassis are removed
for rack installation.
57Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
