Juniper SRX220 Hardware Guide

Table 4: SRX220 Services Gateway Hardware Features (continued)
SRX220 Services Gateway
with PoE (SRX220H-POE)SRX220 Services Gateway (SRX220H)Feature
1 externally accessible1 externally accessibleCompactFlash
NOTE: The PoE LED is enabled only on the SRX220H-POE model of the
SRX220 Services Gateway. On the SRX220H model, the PoE LED is disabled.
For more details on the SRX220 Services Gateway software features and licenses, see
the Initial Configuration for Security Devices.
Related
Documentation
SRX220 Services Gateway Description on page 3•
• SRX220 Services Gateway Specifications on page 29
SRX220 Services Gateway PoE Overview
This topic includes the following sections:
•
Introduction on page 5
•
PoE Classes and Power Ratings on page 6
Introduction
Power over Ethernet (PoE) is the implementation of the IEEE 802.3af and IEEE 802.3at
standards, which allow both data and electric power to pass over a copper Ethernet LAN
cable.
The SRX220 Services Gateway with Power over Ethernet (SRX220H-POE) model of the
SRX220 Services Gateway supports PoE on eight ports, which supply electric power over
the same ports that are used to connect network devices. The PoE ports let you plug in
devices that require both network connectivity and electric power, such as IP phones and
wireless access points.
You can configure the services gateway to act as power-sourcing equipment for devices
connected on the designated ports.
Table 5 on page 5 lists the SRX220 Services Gateway PoE specifications.
Table 5: SRX220 Services Gateway PoE Specifications
ValuesPower Management Schemes
•
IEEE 802.3af.
•
IEEE 802.3at (PoE+).
•
Legacy (pre-standards).
Supported standards
5Copyright © 2016, Juniper Networks, Inc.
Chapter 1: System Overview

Juniper SRX220 Specifications

General

Brand	Juniper
Model	SRX220
Category	Gateway
Language	English