CHAPTER 2
Hardware Component Overview
•
SRX220 Services Gateway Mini-Physical Interface Modules on page 9
•
SRX220 Services Gateway Boot Devices and Dual-Root Partitioning Scheme on page 9
SRX220 Services Gateway Mini-Physical Interface Modules
The SRX220 Services Gateway has two slots for Mini-Physical Interface Modules
(Mini-PIMs).
A Mini-PIM is a network interface card that is installed on the services gateway to provide
physical connections to a LAN or WAN. The Mini-PIMs supported on the services gateway
are field-replaceable; they can be are removed and inserted into the device. You can
install Mini-PIMs into the two Mini-PIM slots on the front panel of the services gateway
chassis.
For more information about supported Mini-PIMs, including how to install and configure
Mini-PIMs, see the SRX Series Services Gateways for the Branch Physical Interface Modules
Hardware Guide.
NOTE: The Mini-PIMs available for the SRX220 Services Gateway do not
support hot swapping. You must power off the device and then unplug its
power cord or power supply adapter before removing or installing Mini-PIMs.
Related
Documentation
SRX220 Services Gateway Description on page 3•
• SRX220 Services Gateway Specifications on page 29
• SRX220 Services Gateway Hardware Features on page 4
• SRX220 Services Gateway Built-In Interfaces on page 13
SRX220 Services Gateway Boot Devices and Dual-Root Partitioning Scheme
This topic includes the following sections:
•
Boot Devices on page 10
•
Dual-Root Partitioning Scheme on page 10
9Copyright © 2016, Juniper Networks, Inc.
To Next Page
Loading...
Need help?
General
