Juniper SRX320 Hardware Guide

CHAPTER 14
Installing the SRX320 Services Gateway
•
Installing the SRX320 Services Gateway in a Rack on page 53
•
Installing the SRX320 Services Gateway on a Desk on page 56
•
Installing the SRX320 Services Gateway on a Wall on page 57
Installing the SRX320 Services Gateway in a Rack
You can front-mount the SRX320 Services Gateway in a rack. Many types of racks are
acceptable, including four-post (telco) racks, enclosed cabinets, and open-frame racks.
For more information about the type of rack or cabinet the SRX320 Services Gateway
can be installed in, see “SRX320 Services Gateway Rack Size and Strength Requirements”
on page 29.
NOTE: The rack-mounting kit is not shipped with the device and must be
ordered separately.
NOTE: If you are installing multiple devices in one rack, install the lowest one
first and proceed upward in the rack. Ensure that the rubber feet from the
base of the chassis are removed for rack installation.
To install the device in a rack:
53Copyright © 2016, Juniper Networks, Inc.

Juniper SRX320 Specifications

General

Firewall throughput	1000 Mbit/s
Number of users	50 user(s)
Quality of Service (QoS) support	Yes
Mobile VPN IPSec	250
IPS/IDS throughput	100 Mbit/s
USB 2.0 ports quantity	1
Connectivity technology	Wired
SFP module slots quantity	2
Ethernet LAN (RJ-45) ports	6
Internal memory	4000 MB
Flash memory	8000 MB
Storage media type	Flash
Power consumption (typical)	27 W
Heat dissipation	157 BTU/h
Concurrent connections	64000
Mean time between failures (MTBF)	284700 h
Storage temperature (T-T)	-20 - 70 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	5 - 95 %
Operating relative humidity (H-H)	10 - 90 %
Routing protocols	BGP, CLNS, IS-IS, OSPF, RIP-1, RIP-2

Weight and Dimensions

Weight	1510 g
Dimensions (WxDxH)	299.9 x 43.9 x 191 mm