7½ Digit Graphical Sampling Multimeter Calibration Manual Section 2:
DMM7510-905-01 Rev. A / April 2015 2-9
Performing the verification test procedures
The following topics provide a summary of verification test procedures and items to take into
consideration before performing any verification test.
Test summary
Front-panel tests:
• DC voltage verification (on page 2-10)
• AC voltage verification (on page 2-13)
• Digitize voltage verification (on page 2-16)
• Analog trigger voltage verification (on page 2-19)
• Analog trigger current verification (on page 2-25)
• Frequency verification (on page 2-32)
• Simulated thermocouple type J temperature verification (on page 2-33)
• Simulated RTD temperature verification (on page 2-34)
• Dry circuit resistance verification (on page 2-37)
• Resistance verification (on page 2-40)
• DC current verification (on page 2-45)
• Digitize current verification (on page 2-51)
• AC current verification (on page 2-56)
• Capacitance verification (on page 2-58)
• Verifying zeros using a 4-wire short (on page 2-62)
Rear-panel tests:
• DC current 10 A range verification (on page 2-63)
• Digitize current 10 A range verification (on page 2-66)
• AC current 10 A verification (on page 2-67)
If the Model DMM7510 is not within specifications and is not under warranty, see the calibration
procedures in Calibration (on page 3-1
) for information about calibrating the unit.
To Next Page
Loading...
Need help?
General
