iMPORTANT SAFETY iNSTRUCTIONS
Your sewing machine is designed and constructed only for HOUSEHOLD use.
Read all instructions before using this sewing machine
DANGER-Toreduce the risk of electric shock:
1. This sewing machine should never be left unattended when plugged in_Always unplug this sewing machine from the
electdc outlet immediately after using and before clea_ing
2. Always unplug before replacing a sewing machine bulb Replace bulb with same type rated 15 Watts
3 Do not reach for a sewing machine that has fallen into water Unplug immediately
4. Do not place or store this sewing machine where it can fall or be pulled into a tub or sink Do not place or drop it into water
or other liquid
WA RNiNG - To reduce the risk of burns, fire, electric shock, or injury to persons:
1 Do not allow this sewing machine to be used as a toy. Close attention is necessary when this sewing machine is used by
or near children
2. Use this sewing machine only for its intended use as described in this owner's manual
Use only attachments recommended by the manufacturer as contained in this owner's manual.
3 Never operate this sewing machine if it has a damaged cord or plug, if it is not working properly, if it has been dropped
or damaged, or dropped into waten
Return this sewing machine to the nearest Sears store or service center for examination, repair, electrical or mechanical
adjustment°
4 Never operate this sewing machine with any air opening blocked Keep ventilation openings of this sewing machine and
foot controller free from accumulation of lint, dust and loose cloth.
5_ Never drop or insert any object into any opening.
6 Do not use outdoors
7. Do not operate where aerosol (spray) products are being used or where oxygen is being administered_
8 To disconnect, turn all controls to the off (" 0") position, then remove plug from outlet
9_ Do not unplug by pulling on cord To unplug, grasp the plug, not the cord
10_Keep fingers away from all moving parts_ Special care is required around the sewing machine needle.
11oAlways use the proper needle plate_ The wrong plate can cause the needle to break_
12. Do not use bent needles
13 Do not pull or push fabric while stitching It may deflect the needle causing it to break
14. Switch this sewing machine off (" C)") when making any adjustment in the needle area, such as threading the needle,
changing the needle, threading the bobbin or changing the presser foot, and the like.
15 Always unplug this sewing machine from the electrical outlet when removing covers, lubricating, or when making any
other adjustments mentioned in this owner's manual
SAVE THESE INSTRUCTIONS
When using your sewing machine for the first few times, place a waste fabric under the presser foot and run i
the machine without thread for a few minutes. Wipe away any oil which may appear,
J
To Next Page
Loading...
Need help?
General
