Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position
by turning the handwheel counterclockwise, toward
you.
" Raise the presser foot lifter,r
* Place a spool on the spool pin, with thread coming
off as shown_
[] Draw the end of thread around the upper thread guide.
[] While holding the thread near the spool, draw the
end of the thread down around the check spring
holder,,
[] Firmly draw the thread up from right to left over
the take-up lever and down into the take-up lever
eye.
[] Slide the thread behind the needle bar thread
guide on the left..
[] Thread the needle from front to back or use a
needle threader.
We recommend using the convenient needle
threader (#200262101), included with your
machine..
J
o Drawing up bobbin thread
[] Raise the presser foot. Hold the needle thread
lightly with your left hand and rotate the handwheel
counterclockwise, toward you, for one complete turn.
[] Bring the bobbin thread up by pulling the needle
thread up.
[] Pull both threads under and to the back of the
presser foot, leaving 4" to 6" (lOcm to 15cm)
of thread clear.
[]
[]
[]
24
To Next Page
Loading...
Need help?
General
