Bobbin Winding
• Removing bobbin case
Remove the extension table from the machine by pulling it to
the lefto Open the shuttle cover _ by pulling down the em-
bossed part on the left of the cover.
Raise the needle to its highest position by rotating the
handwheel toward you_
(_ Shuttle cover
1_) Bobbin case
To remove the bobbin case(_) from the shuttle, pull open the
latch of the bobbin case_ Pull the bobbin case straight out of
the shuttle.
• Bobbin winding
IT]Release the clutch by pulling out the handwhee!. This
will stop the needle from moving while you wind the
bobbin.
[]
[] Draw thread from spool.
[] Guide the thread around the thread guide..
[] Thread through the hole in the bobbin from the inside to
the outside.
[] Put the bobbin on the bobbin winder spindle.
[] []
[]
18
To Next Page
Loading...
Need help?
General
