OPERATION 5-3
1. Applying the parking brake.
Pull the parking brake lever while fully
depressing the brake pedals. (The left
and right pedals should already be
latched together for this procedure).
The “P” lamp in the instrument panel
will turn on when the key switch is
turned on; indicating that the parking
brake is ON.
C71O501B
(1) Parking Brake Lever
CHANGING LUBRICATING OIL FOR
NEW TRACTOR
In handling a new tractor, the following
precautions should be observed.
You should not operate your tractor at
full speed for the first fifty hours of
use.
Avoid sudden starts and stops.
In cold climates, allow your tractor
plenty of time to warm up.
Do not run the engine at speeds faster
than necessary.
Use due caution when operating your
tractor on rough roads or terrain.
The above precautions are not limited to
new tractors only, but are a good prac-
tice for tractors regardless of their age.
Special attention should be given to new
tractors lubrication oil. New parts are not
accustomed to each other and are not
broken in properly. Small metal grit can
develop in the lubricating system as metal
parts begin to “break in” and continuous
use of the contaminated oil can cause
damage and failure.
Therefore you should change the
tractor’s oil after the break-in period.
For further details of the oil change and
service schedule, see “maintenance”
section.
STARTING THE ENGINE
OPERATING THE ENGINE
To Next Page
Loading...
Need help?
General
