6-12 DK65S
CLEANING AND CHANGING THE AIR
CLEANER ELEMENT
C71O614B
(1) Air Cleaner
1. Remove the wing-nut and remove the
cover. Carefully remove the filter
element.
2. Clean the element by blowing the dust
from the inside out using compressed
air. Air pressure should not exceed 30
PSI, and keep the nozzle at a safe dis-
tance to avoid damage to the filter
element.
3. Extremely dirty or oily elements must
be replaced. Replace the element in
accordance with the maintenance
schedule for best performance.
AIR CLEANER SERVICING PRECAUTIONS
1. Use only genuine replacement filter
elements. Do not use oil in this filter.
2. Carefully clean dust from inside the air
cleaner canister. Be careful not to al-
low dust into the air intake.
3. Ensure the filter element is firmly
seated and that the canister cover is
properly aligned and securely fastened.
Any leak in the air cleaner system may
allow dust ingestion which can cause
severe engine damage.
4. Never operate the engine without the
air cleaner properly installed.
1. Remove the drain plug at the bottom
of the transmission case and drain the
oil completely into the oil pan.
2. After draining,reinstall the drain plug.
3. Remove the oil filter.
4. Place a film of clean transmission fluid
of the rubber seal of the new filter.
5. Tighten the filter firmly until it contacts
the mounting surface. Then tighten the
filter, by hand, an additional half turn
only.
To Next Page
Loading...
