1. This tractor is not equipped with a
separate parking brake. However
uses the brake pedals instead.
(1) Parking Brake Lever
(4) Chocks
PARKING
TE1O507B
2. Make sure to interlock the left and
right brake pedals before applying
the parking brake.
3. Pull the parking brake lever (2) up
with the brake pedals depressed
fully to engage the pedals with the
latch. If the braking force is insuf-
ficient, depress the pedals more
rmly.
4. Before leaving the tractor after
parking it, make sure to stop the
PTO, lower the implement onto the
ground, and stop the engine.
5. If it is necessary to leave the trac-
tor with the engine running, put all
the shift levers in the neutral posi-
tion and apply the parking brake
rmly.
6. When parking the tractor on a
slope, stop the engine with the
parking brake applied and engage
the low speed gear. Also, put the
shuttle shift lever into the forward
driving position on an uphill and
into the reverse driving position on
a downhill.
Never put a foot on the clutch
pedal during driving. The clut-
ch disc can be rapidly worn.
Make sure to operate the
clutch fast when disengaging
it and slowly when engaging it.
Do not change the tractor
speed abruptly for safe driving.
When driving on a slope or
loading or unloading the trac-
tor to a transporting vehicle,
reduce the speed in advance
so that there is no need to shift
the gear in the middle of the
slope. Also, do not put your
hand on the shift lever while
driving on a slope. The tractor
may roll down the slop due to
the disengaged gear which is
very dangerous.
CAUTION
To Next Page
Loading...
Need help?
General
