(1) Plug
DRAINING WATER FROM CLUTCH HOUSING (AK)
1. There is a plug under the clutch
housing.
2. Drain the water completely and
install the plug. Drain the water
into a container and dispose of it in
a proper manner for environment
protection.
3. Make sure to install the plug and
not to damage the clutch severely.
TE1O734A
If you forget to install the plug,
the clutch can be damaged.
Foreign material can enter
through the open drain hole.
•
IMPORTANT
(1) Wiper
CHECKING & REPLACING WIPER (AL)
INSPECTION
Check the operation and wear of the
wiper blades frequently. To replace the
wiper blade, press the wiper xing le-
ver to separate it and then pull it away.
To remove the wiper arm, lift the cap
of the wiper arm, remove the nut, and
set the wiper arm upright. Then, hold
the arm head and shake it left and
right to remove the wiper arm from the
drive spindle. Disconnect the washer
uid hose and then install a new wiper
arm to its position by aligning it to the
proper angle.
TE1O735A
To Next Page
Loading...
Need help?
General
