(1) Oil Dipstick
(A) Lower Limit (B) Upper Limit
1. Park the machine on a at surface,
lower the implement and shut off
engine.
2. Depress the brake pedals and ap-
ply the parking brake.
3. Set all shift levers into the neutral
position.
4. Stop the engine.
(1) Oil Filler Plug & Gauge
(A) Oil level is acceptable within range
CHECKING TRANSMISSION
FLUID LEVEL (C)
5. Pull out the oil dipstick, clean it,
and then insert it into its original
position. Then, pull it out again and
check if the fuel level is within the
specied range.
6. If the oil level is too low, add some
new oil so that the level is within
the allowable range. (Refer to "Lu-
brication" in the chapter "Service")
TE1O703B
T11O750A
If oil level is low, do not run
engine.
Never add the oil over the up-
per limit.
•
•
IMPORTANT