(1) Fuel Pipe (2) Tightening Band
CHECKING FUEL LINES (S)
Although checking the fuel pipe con-
nection is recommended every 100
service hours, it should be done ev-
ery 6 months if operation does not
exceed 100 hours in 6 months.
1. If the hose clamps are loose, apply
a slight coat of lubricant onto the
threads and securely tighten it.
2. The fuel pipe is made of rubber
and ages regardless of period of
service. Change the fuel pipe to-
gether with the hose clamps every
two years and securely tighten.
3. If the fuel pipes and hose clamps
are found damaged or deterio-
rated earlier than two years, then
change them immediately.
4. After the fuel pipe and hose
clamps have been changed, bleed
the fuel system.
EVACUATOR VALVE
Open the evacuator valve once a
week under ordinary conditions or
daily when used in dusty conditions
to get rid of large particles of dust
and dirt.
Do not run the engine with l-
ter element removed.
Be sure to refit the cap with
the arrow (on the rear of
cover) upright. If the cap is
improperly fitted, evacuator
valve will not function and
dust will adhere to the ele-
ment.
IMPORTANT
扌
TE1O754A
F Series ENGINE
A&B Series ENGINE
To Next Page
Loading...
Need help?
General
