Kohler Curtis F Series User Manual

4 — PROGRAMMABLE PARAMETERS
pg. 41
Return to TOC Curtis AC F2-A, F4-A, F6-A Motor Controllers – FOS 4.5 – April 2022
CONTROL MODE SELECT INDEX
Table 18 Programmable Parameters Menus: Curtis Integrated Toolkit
TM
/1313 HHP
Application Setup: menu index Controller Setup: menu index Motor Setup: menu index
APPLICATION SETUP....................... p.62
— Throttle
— Brake
— Can Interface
— Can Interface 2
(only 35-pin controllers)
— Battery Setup
— Main Contactor
— EM Brake Control
— EM Brake Test
— Emergency Reverse (EMR)
— Interlock Braking
— Hydraulics (as a pump controller)
— Dual Drive (see manual supplement)
— Vehicle
— Max Speed Supervision
— Motor Not Stopped
— Hazardous Movement
— Motor Braking Supervision
— IMU
CONTROLLER SETUP............... p.104
— Inputs
— Analog 1-31
— IO Assignments
— Controls
— Switch Assignment
— Switch Status
— Coil Drivers
— Outputs
— Drivers 1-7
— External Supplies
— Current Limits
— Power Limits
Until the motor type is selected, AND the applicable motor characterization and setup is
complete, the default CIT Programmer will show these motor related faults. Follow the parameter
programming setup instructions related to each fault to clear and verify commissioning.
NOTICE
Default Faults: prior to motor selection, setup and commissioning.
— Motor Temp Sensor
— * Parameter Change
— * Motor Temp Hot Cutback
— Motor Setup Needed
* Controller and device profile basis.
PARAMETER CATEGORY AND MENU INDEX
CONTROL MODE SELECT........ p.49
— Speed Mode Express..........p.51
— Application Setup...............p.62
— Controller Setup...............p.104
— Motor Setup.....................p.131
CONTROL MODE SELECT.......... p.49
— Speed Mode.......................p.52
— Application Setup................p.62
— Controller Setup................p.104
— Motor Setup......................p.131
CONTROL MODE SELECT......p. 49
— Other Modes.......................p. 49
— Application Setup................p.62
— Controller Setup................p.104
— Motor Setup......................p.131
CONTROL MODE SELECT...... p.49
— Torque Mode.......................p.59
— Application Setup................p.62
— Controller Setup................p.104
— Motor Setup......................p.131
MOTOR SETUP.............................. p.131
— Induction Motor (ACIM)
— Field Weakening
— Limited Operating Strategy
— Characterization Tests
— Current Regulator
— Motor Setup Status
— Quadrature Encoder
— Encoder Fault Setup
— Speed Filters
— PMAC (Permanent Magnet Motor)
— Commissioning Tests
— Motor Data Values
— Commissioning Results
— Motor Setup Status
— Sin/Cos Encoder
— Temperature Sensor

Kohler Curtis F Series Specifications

General

Brand	Kohler
Model	Curtis F Series
Category	Controller
Language	English