Kohler Decision-Maker 3000 User Manual

141Section 8 Component Testing and AdjustmentTP-6356 4/12
8.17 Remote Serial Annunciator
(RSA II)
Adapted from Instruction TT-1485 1/11f.
The following information summarizes the setup items
when troubleshooting the remote serial annunciator
(RSA). Refer to the RSA installation instructions for
operation and function. See Figure 8-31 and
Figure 8-32 for RSA front panel illustration. See Section
8.19, Communication Module and Gauge Driver Circuit
Board.
8.17.1 RSA II Features and Connectors
All RSA II annunciators are factory set as the master
device, but can be changed to a slave device using a PC
and SiteTecht software that connects to the RSA II
front panel via a universal serial bus (USB) connection.
See Figure 8-33 for the circuit board connectors.
The RSA 1000 can be connected with the RSA II
provided that the master remote annunciator is an
RSA II.
The RSA annunciates faults using LEDs and an alarm
horn. Press the Alarm Silence/Lamp Test switch to test
the RSA indicator LEDs and horn. If the horn is activated
by a fault condition, press the Alarm Silence/Lamp Test
switch to quiet the alarm during servicing. The horn will
reactivate upon additional tests.
/Aux.
Figure 8-31 Remote Serial Annunciator (RSA II)
Figure 8-32 RSA II with ATS Controls

Kohler Decision-Maker 3000 Specifications

General

Brand	Kohler
Model	Decision-Maker 3000
Category	Controller
Language	English