SEN04132-01 50 Disassembly and assembly
26 PC130-8
Removal and installation of front
wiper assembly
k Place the machine on a level ground, lower
the work equipment to the ground, and
stop the engine.
k Place the work equipment lock lever in
LOCK position.
k Turn the battery disconnect switch to OFF
position, and remove the key.
Removal
1. Check that wiper arm (1) is stowed in the right
st
ay.
2. While holding grips (2) on the right and left of
the fr
ont window, pull lever (3) forward to
release the lock.
3. Pull up lower grip (4) by left hand and upper
grip
(5) by right hand, and push them to lock
catch (6) at the rear of the cab to lock.
To Next Page
Loading...
Need help?
General
