Checking cab tipping stopper 1
a Check the cab tipping stopper according to the
following procedure.
1. Remove the additional undercover from the
rear of the operator's cab.
2. Check the tightening torque of the mounting
bolt (2) of the lock plate (1).
3 Bolt (2): 98  123 Nm {10  12.5 kgm}
[Reference]
q The tightening torque of mounting bolt (4) of
cab tipping stopper (3) is different from that of
a common bolt 30 mm in diameter. Take care.
3 Bolt (4): 245  309 Nm {25  31.5 kgm}
To Next Page
Loading...
Need help?
General
