Checking and adjusting air
conditioner compressor belt
tension 1
k Stop the machine on a level ground and
lower the work equipment to the ground.
Checking
1. Open the engine hood and remove fan guard
(1).
2. Press the intermediate point of the belt
between fan pulley and compressor pulley with
a finger and measure deflection (a) of the belt.
q Belt pressing force: 60 N {6.1 kg}
Adjusting
a If the belt deflection is abnormal, adjust it
according to the following procedure.
1. Loosen bolts (1) and (2).
2. Move compressor (3) and bracket (4) together
to adjust the belt tension.
3. After positioning compressor (3), tighten bolts
(1) and (2).
a Check each pulley for breakage, wear of
the V-groove, and contact of the V-belt
and V-groove.
a If the V-belt is so lengthened that the
adjustment allowance is eliminated or it
has a cut or a crack, replace it.
a If the belt is replaced, adjust their tension
again after operating the machine for 1
hour.
a After tightening the bolts, check the belt
tension again according the above proce-
dure.
4. After finishing test, return the removed parts.
To Next Page
Loading...
Need help?
General
