SEN04128-01 50 Disassembly and assembly
2 PC130-8
Removal and installation of travel
motor and final drive assembly 1
Removal
1. Remove sprocket.
For details, see "Removal and installation of
sp
rocket".
k Lower the work equipment completely to
the ground and stop the engine. Then
loosen the oil filler cap slowly to release the
pressure inside the hydraulic tank.
2. Disconnect 4 mounting bolts (1) and remove
t
ravel motor cover (2).
3. Disconnect 4 travel motor hoses (2).
4. Remove all travel motor and final mounting
bo
lts (4), except 1.
5. Sling the travel motor and final drive assembly
(5) and remove mounting bolt.
6. Lift off travel motor and final drive assembly.
[*1]
a Be
extremely careful not to damage the
nipple tool surface of the hose mount.
4 Travel motor and final drive assembly:
150 kg
To Next Page
Loading...
Need help?
General
