50 Disassembly and assembly SEN04130-01
PC130-8
29
q Installed height: 31.9 mm (Common to
both springs)
q Installed load:
Spring (6) (P1, P2): 35.3 N {3.6 kg}
Spring (7) (P3, P4): 21.6 N {2.2 kg}
3 Bolt (9): 11.8 – 14.7 Nm {1.2 – 1.5 kgm}
a When
installing joint (12) to body (1), apply
LOCTITE as shown below.
1) When installing the joint,
apply 1 drop
(approx. 0.02 g) of LOCTITE (No. 262)
each to 2 places of the female screw (A)
of the body. Before installing the joint,
thoroughly degrease and dry its male
screw and the female screw of the body
with DRYSOL.
2) Drop LOCTITE to the following positions.
2 Female screw (A) of body:
LOCTITE No. 262
3 Joint (10): 39 – 49 Nm {4 – 5 kgm}
a Apply gre
ase (G2-LI) to the rocking part of joint
(12) and the contact surfaces of disc (13) and
piston (8).
2 Quantity of grease (G2-LI)
1) Rocking part of joint: 2 – 4 cc/periphery
2) Contact surfaces of disc and piston:
0.3 – 0.8 cc/place
To Next Page
Loading...
